This listing is for UVB1-CP-R Receiver only. Use
description below as a general reference.
This product is used to receive a video signal on Cat5 cable from up to 1,000 ft
away and output it as normal Component Video at SD or HDTV resolutions.
typical installation 2 units are required, one as a sender (UVB1-CP-S) and one as a
receiver (UVB1-CP-R). They are also sold as a kit (see Model UVB1-CP).
other passive Baluns this device is active and receives the signal using wide
bandwidth (550 MHz) differential (balanced) amplifiers for an unprecedented sharp and
The unit provides Ground-loop Isolation (GLI) and RFI (radio
frequency interference) immunity to prevent 60 cycle video hum or distortion. Most
competing Baluns provide no common mode rejection at low frequencies and are subject
to facility grounding issues and noise pickup.
The active design matches the
impedance of the UTP cable perfectly at all frequencies so that there is no image
ghosting. Ghosting is a major issue with competing passive Baluns transmitting HD
- Receives component video (YPbPr)
over CAT 5 cable
- Up to 1000 feet (depending on the resolution)
be powered via Cat5 Cable
- Wide bandwidth differential amplifiers for
unprecedented sharp and clean image
- Ground-loop Isolation (GLI) and RFI
(radio frequency interference) immunity
- Active design impedance matching for
no image ghosting