This listing is for DB-TPS1A Transmitter only. Use
description below as a general reference.
The D SERIES-TPS1A modules are single-pair audio sending modules compatible
with RDL Format-A twisted pair products. These modules are designed to be mounted in
wall boxes, cabinets or other enclosures that allow users to connect audio sources.
The -TPS1A models mount in RDL WB-1U and WB-2U wall boxes, or in standard U.S.
electrical boxes. The D-TPS1A features a white front-panel laminate with gray
lettering that matches RDL Decora©-style remote controls. The DB-TPS1A features a
black front-panel laminate. The DS-TPS1A is constructed of stainless steel to
coordinate with RDL Decora-style stainless steel remote controls in commercial/
APPLICATION: The D SERIES-TPS1A modules feature
an XLR microphone input. The module provides IEC 24 V phantom and accepts input
signals from both dynamic and condenser microphones. The input signal is amplified
using a studio-quality microphone preamplifier optimized for normal operating
levels. The rear-panel GAIN switch is normally set by the installer for NORM
(normal) gain. If consistently low mic levels are expected, this switch may be set
to the HIGH gain position. The pre-amplified microphone source is routed to one
output cable pair selected during installation using a rear-panel switch.
These modules drive only one cable pair, therefore they accept signals and power
from other mic-level or line-level Format-A senders. The D SERIES-TPS1A modules have
a second RJ45 jack for these input cables. Two other single-pair senders may be
chained with the -TPS1A, or a single two-pair sender may be connected. If three
single-pair senders are connected together, each sender must feed a different pair:
A, B or C. The -TPS1A must be set to feed pair A if it is connected together with an
RDL two-pair sender that feeds stereo audio on pairs B and C. The power pair and all
three audio pairs are fed through both rear-panel RJ45 jacks.
The D SERIES-
TPS1A may be powered directly from a 24 Vdc power supply using the rear-panel
detachable terminal block. Local power connected to the module is also fed to all
connected remote modules. The -TPS1A may be remotely powered through the twisted
pair cable from any other module, signal distributor or RDL power inserter connected
to the same twisted pair cable. Module power is indicated by a front-panel LED.
RDL FORMAT-A features superior audio performance that rivals or exceeds shielded
wiring. Design simplicity, ease of installation, unsurpassed flexibility, automatic
fused power, exceptional hum rejection, low noise, and low distortion provide
designers and installers the optimum choice in economical twisted pair products.
- Balanced Microphone XLR Input with
- Switch-Selectable Mic Gain on Rear Panel
- Switch Selects
which RJ45 Pair (A, B or C) is Fed
- Signal and Power Pair Pass-Through on
- Remote Powering through Twisted Pair Cable
Local Power Feeds all Connected Modules
- Local Power Input on Terminal
- Blue LED Indicates Module is Powered
- Daisy-Chain with
Single-Pair or Two-Pair Senders
- Studio-Quality Precision Active Balanced